Care Guide AirCore P2

Care Guide — AirCore P2

Weekly

  1. Wipe the exterior housing and intake grilles with a dry or lightly damp microfibre cloth. Dust accumulates on the grilles and reduces intake airflow over time. Do not spray any liquid directly onto the unit.

Monthly

  1. Check the filter life indicator on the display or in the Monverta Home app. If it reads below 20%, order a replacement filter — do not wait for it to reach 0% before acting.
  2. Vacuum the intake grilles lightly using a soft brush attachment. This removes surface dust that the cloth cannot reach.

Every 6 months

  1. Clean the exterior sensor port (small opening on the side panel near the display). Use a dry cotton bud to gently clear any dust from the sensor aperture. A dirty sensor will read air quality inaccurately.

Filter Replacement

The AirCore P2 uses a combined H13 HEPA and activated carbon filter. Do not wash the filter — it is not washable and water will destroy the HEPA medium.

Replace the filter when the indicator reaches 10% or approximately every 8–12 months under standard domestic use. In high-dust environments (renovation, pet households, heavy cooking), replacement may be needed more frequently.

To replace

  1. Open the rear filter access panel by pressing the two side tabs.
  2. Grip the filter frame and pull outward.
  3. Insert the new filter with the airflow direction arrow pointing into the unit.
  4. Close the panel until both tabs click.
  5. Reset the filter counter by pressing and holding the Filter button on the top panel for 5 seconds.

Replacement filter: MV-FLTR-P2 (standard) or MV-FLTR-P2-PLUS (enhanced carbon layer for VOC-heavy environments). Available at monverta.com/accessories.

Display and Sensor Care

Do not place the unit in direct sunlight — prolonged UV exposure affects the particulate sensor calibration. Keep the area around the unit clear to allow unobstructed airflow on all sides.