Care Guide — AquaDry S1

After Every Use

1. Return the unit to the dock. The automatic self-clean cycle will run for 60 seconds — let it complete before unplugging.
2. Empty the dirty water tank and rinse it under a running tap. Reattach empty.
3. Empty and refill the clean water tank with fresh water before the next use. Do not leave stale water in the tank.

Weekly

1. Remove the roller and rinse under warm running water. Squeeze gently to clear accumulated residue. Allow to air dry for at least 1 hour before reattaching.
2. Wipe down the roller housing channel inside the machine with a damp cloth. This is where detergent residue and floor debris collect most rapidly.
3. Wipe the exterior of the unit and dock with a damp cloth.

Monthly

1. Run a deep self-clean: fill the clean tank with a solution of 1 part white vinegar to 5 parts water. Dock the unit and hold the power button for 3 seconds to trigger the extended flush cycle. Follow with a rinse cycle using clean water only.
2. Inspect the door seals on both tanks for debris trapped across the seal surface. Clear with a dry cloth.

Roller Replacement

Replace the cleaning roller every 3 months under regular use, or sooner if discolouration does not clear after self-clean. A worn or permanently discoloured roller is less effective and is the most common cause of poor cleaning performance. Part: MV-RLR-S1.

Cleaning Solution

Use only low-foam hard floor cleaning solutions. Do not use bleach, abrasive cleaners, or heavily fragranced products — they degrade the roller material and internal seals. Monverta floor solution is compatible and available at monverta.com/accessories.

Storage

If storing for more than 2 weeks, empty both tanks completely, run a self-clean cycle, remove the roller, and allow all components to dry before reassembling. Store in a dry location away from direct heat.