Care Guide — CleanLift A9

After Every Use

1. Empty the dustbin. Debris left in the bin reduces suction in subsequent uses and can cause odour.
2. Remove the brush roll and clear any hair or thread from the bristles and end caps. This takes less than a minute and prevents the most common performance issue.
3. Return the unit to the charging dock.

Monthly

1. Wash the post-motor filter. Remove it from the body (purple tab above the dustbin), rinse under cold running water until the water runs clear, and leave to air dry for a minimum of 24 hours before refitting. Do not use a dryer or direct heat. Never run the machine with a damp filter.
2. Rinse the dustbin with cold water and allow to dry before reattaching.
3. Wipe the floorhead sole plate and brush roll housing with a damp cloth to remove accumulated residue.

Every 6 months

1. Wipe down the wand, body, and dock with a damp microfibre cloth. Pay particular attention to the connection points between the wand sections — debris build-up here can reduce airflow.
2. Inspect the wand connections and release buttons. Apply a small amount of silicone-free dry lubricant to stiff release mechanisms.

Consumable Replacement

• Filter: Replace every 12 months regardless of cleaning frequency. Part: MV-FLT-A9.
• Brush roll: Replace when bristle height is visibly reduced or cleaning performance does not recover after cleaning. Part: MV-BR-A9.

Storage

Do not store the A9 in damp environments or in direct sunlight. The battery should be stored at 40–80% charge for long-term storage (over 30 days). Avoid leaving the unit permanently on the charger for more than 72 hours continuously.