Espresso Studio Pro

Espresso Studio Pro Care Guide

Regular maintenance keeps your Espresso Studio Pro (MV-ESP1-AN-SS) performing at its best and extends the life of critical components. Follow this schedule to prevent build-up, ensure consistent extraction, and keep your machine in warranty.

After Every Use

  1. Purge the steam wand. Open the steam valve for 2–3 seconds immediately after steaming to blow out any milk residue from inside the wand tip. Wipe the wand from top to bottom with a damp cloth while it is still warm.
  2. Knock out the puck and rinse the portafilter. Remove the portafilter, knock the spent puck into a knock box, and rinse the basket and portafilter under hot running water. Do not use detergent for this daily rinse.
  3. Flush the group head. With the portafilter removed, run the brew pump for 3–5 seconds to rinse loose coffee grounds from the shower screen and dispersion block.
  4. Wipe the machine exterior. Use the included microfibre cloth to wipe down the stainless-steel body, drip tray surround, and cup warming tray. This prevents water spots and coffee stains from setting.

Daily (End of Day)

  1. Backflush with water. Insert the cleaning disc (blind basket) into the portafilter. Lock it into the group head. Run the brew pump for 10 seconds, then stop. Repeat 3 times. This forces water back through the three-way solenoid valve, clearing oils and residue from the internal brew path. Remove the cleaning disc and run one final flush with the empty portafilter.
  2. Empty and rinse the drip tray. Slide the drip tray out, discard the liquid, rinse under the tap, and replace. Check the drip-tray-full LED indicator — do not let it overflow.
  3. Soak the steam wand tip. If milk has dried on the tip, unscrew the 4-hole steam tip and soak it in warm water for 10 minutes. Use the included pin to clear any blocked holes. Screw the tip back on firmly.

Weekly

  1. Backflush with cleaning tablet. Insert the cleaning disc into the portafilter. Drop one Monverta espresso cleaning tablet (MV-ESP1-TABLET) onto the disc. Lock the portafilter into the group head. Press and hold the 2-cup button for 5 seconds to start the backflush cycle. The machine will run the pump in short bursts for approximately 8 minutes. When complete, remove the portafilter, rinse thoroughly, and run two blank flushes through the group head.
  2. Clean the shower screen. Use a flat-head screwdriver to remove the single centre screw holding the shower screen. Remove the screen and the rubber gasket behind it. Soak both in hot water with a cleaning tablet for 15 minutes. Scrub the screen with a soft nylon brush, rinse, and refit.
  3. Wash the drip tray and grate. Remove the drip tray and its stainless-steel grate. Wash both in warm soapy water or place them in the dishwasher (top rack only).

Monthly

  1. Deep clean the steam wand assembly. Unscrew the steam tip. Submerge the tip and wand sleeve in a solution of warm water and Monverta milk-system cleaner (MV-ESP1-MILK) for 20 minutes. Scrub the inside of the wand tube with the included wand brush. Rinse thoroughly, reassemble, and purge steam for 5 seconds before next use.

Every 6 Months

  1. Replace the water filter cartridge. Remove the water tank, twist the old cartridge (MV-ESP1-FILTER) counter-clockwise to release, and insert a new one. In hard-water areas (above 200 ppm), replace every 3 months instead.
  2. Inspect the group head gasket. With the portafilter removed, visually inspect the rubber gasket seated inside the group head. If it appears cracked, flattened, or hardened, replace it with a new gasket (MV-ESP1-GASKET). A worn gasket causes leaking around the portafilter during extraction.
  3. Descale the thermoblock. Follow the full descaling procedure outlined in the how-to guide, using Monverta descaling solution (MV-ESP1-DESCALE). The descale LED indicator on the front panel will illuminate when descaling is due.

Consumables and Replacement Parts

Item Part Number Replacement Interval
Cleaning tablets (pack of 8) MV-ESP1-TABLET Weekly backflush — approx. every 2 months per pack
Descaling solution (500 ml) MV-ESP1-DESCALE Every 2–3 months (or when prompted)
Water filter cartridge MV-ESP1-FILTER Every 6 months (3 months in hard-water areas)
Group head gasket (58 mm) MV-ESP1-GASKET Every 6–12 months depending on use
Shower screen (58 mm) MV-ESP1-SCREEN Every 12 months or when visibly worn
Milk-system cleaner (250 ml) MV-ESP1-MILK Monthly deep clean — approx. every 4 months per bottle
Precision basket (18 g) MV-ESP1-BASKET18 Replace if holes become blocked or basket warps

What to Avoid