Care Guide — Oven Studio 800

After Every Use

1. Once the oven has cooled, wipe spills from the cavity floor and oven walls with a damp cloth. Fresh spills are significantly easier to remove than baked-on residue.
2. Remove the wire racks and wash them in hot soapy water or a dishwasher.
3. Wipe down the door glass inside and outside with a damp cloth. Grease build-up on the inner glass will discolour and harden over time.

Monthly

1. Clean the door seal by wiping with a damp cloth. Do not use abrasive pads or cleaning sprays directly on the seal — they degrade the rubber.
2. Wipe the control panel display with a dry microfibre cloth. Do not spray cleaners onto the panel.
3. Remove and clean the telescopic shelf runners if fitted. Pull them fully out, wash in warm soapy water, and allow to dry before refitting.

Every 3–6 months (or when needed)

1. Run a pyrolytic clean cycle. Remove all accessories first. The cycle takes approximately 2.5 hours. After cooling, wipe the ash residue from the cavity with a damp cloth. This is the most effective way to deep-clean the oven interior.
2. Clean the inner door glass panel. It can be removed from the door for easier access — refer to the instruction booklet for the three-step removal process.

What to Avoid

• Never use abrasive cleaning pads, wire wool, or oven sprays inside the pyrolytic cavity — they permanently damage the coating.
• Do not line the oven floor with foil — it traps heat and can damage the element below.
• Do not use steam cleaners on the control panel or door seal.

Door Seal Replacement

Replace the door seal if it shows tears, flattening, or gaps when the door is closed. Part: MV-SEAL-800. A worn seal reduces energy efficiency and cooking performance.