Quick Start — AirCore P2

What's in the box

1. AirCore P2 main unit
2. Pre-installed H13 HEPA filter
3. Pre-installed activated carbon layer
4. Power cable (1.8 m)
5. Remote control (CR2032 battery fitted)

Step 1: Remove all packaging

Lift the P2 clear of the outer box. Remove the plastic bag from the unit body. Open the filter access panel on the rear by pressing the two side tabs and pulling outward. Remove the orange cardboard spacer insert from inside the filter compartment — the unit will not perform correctly if this is left in place. Close the panel until it clicks.

Step 2: Choose a placement location

Place the P2 on a flat surface with at least 20 cm of clearance on all sides and 50 cm above the unit. Do not place it directly against a wall or inside a recess — the unit draws air from all sides and exhausts upward. Avoid placing it in direct sunlight or near heat sources.

Step 3: Power on

Plug in the power cable and press the power button on the top panel. The P2 will run a brief self-test (approximately 5 seconds) and then switch to Auto mode. In Auto mode, the unit adjusts fan speed in response to the onboard air quality sensor.

Step 4: Connect to Wi-Fi

Download the Monverta Home app (iOS and Android). Open the app, tap Add Device, and select AirCore P2. Follow the in-app steps to connect the P2 to your 2.4 GHz Wi-Fi network. Once connected, the Wi-Fi indicator on the display panel will glow a steady white.

Step 5: Understand the display

The front display shows four data points: PM2.5 particle level, VOC index, current fan speed, and filter life remaining. The ambient light ring reflects overall air quality — white is good, amber is moderate, red indicates poor air quality detected.

Step 6: Set a schedule (optional)

In the Monverta Home app, go to Schedules to configure automatic on/off times or Sleep Mode for overnight use. Sleep Mode reduces fan speed and dims the display.

Tips

• Do not wash the HEPA filter with water. It is not washable. Replace when the filter indicator drops to 10%.
• The carbon layer and HEPA filter are replaced together as a combined unit.
• In very dusty environments (renovation, heavy cooking), switch to Boost mode temporarily to clear particulates faster, then return to Auto.