Quick Start — AquaDry S1

What's in the box

1. AquaDry S1 floor washer body
2. Charging and docking station
3. Clean water tank (fitted)
4. Dirty water recovery tank (fitted)
5. Cleaning roller (fitted)
6. Spare cleaning roller
7. Cleaning solution sample (100 ml)
8. Dock power cable

Step 1: Set up the dock

Place the dock on a hard, flat surface near a power outlet. Connect the power cable. The dock charges the S1 and triggers the self-clean cycle automatically when the unit is returned. Allow 1 m of clearance in front of the dock for easy approach.

Step 2: Fill the clean water tank

Remove the clean water tank by pressing the release tab on the rear of the unit and lifting it clear. Fill to the MAX line with clean, cold tap water. Add no more than 10 ml of Monverta floor cleaning solution or a compatible low-foam hard floor cleaner. Reattach the tank until it clicks.

Step 3: Check the dirty water tank

The dirty water tank sits alongside the clean tank. Confirm it is empty and properly seated before starting. A full dirty water tank will stop the machine automatically.

Step 4: First clean

Press the power button. The roller will begin spinning and solution will dispense immediately. Push the S1 forward and backward in slow, overlapping passes. Do not press down — the unit's weight provides the correct contact pressure. Begin at the far end of the room and work backwards toward the door.

Step 5: Empty and rinse after use

Return the unit to the dock. The self-clean cycle runs for 60 seconds, flushing the roller with clean water. After the cycle completes, remove the dirty water tank and pour away the contents. Rinse the tank under a tap and reattach.

Step 6: Run a manual self-clean cycle

For a deeper clean of the roller system, press and hold the power button for 3 seconds while the unit is docked. The S1 will run an extended 3-minute flush cycle.

Tips

• The S1 is for hard floors only. Do not use on carpet or rugs.
• Replace the cleaning roller every 3 months or when discolouration becomes permanent after self-clean.
• Do not use bleach-based cleaners — they will degrade the roller material and damage internal seals.